What it is: With 35K Hz vibrations per minute, the DERMAPORE+ is every estheticians best friend for finger-free extractions with no redness or irritation.What it does: The custom-curved spatula has positively charged ions, which work synergistically with the negatively charged ions in Prep Mist. Together, they act like a magnet to gently extract pore-clogging dirt, oil and blackheads from wet skin. A separate Infuse mode helps deliver skin-care actives deeper into your skin, while boosting circulation with an invigorating micro-massage sensation.Set includes:- DERMAPORE+ Ultrasonic Pore Extractor + Skin Care Infuser- DERMAPORE+ Prep Mist Spray (0.5 oz.)- USB charging cordHow to use: Use once per week until skin becomes accustomed, then use as often as desired. Always use with PREP MIST for maximum pore-clearing benefits. Skin must remain wet during the entire treatment. Make sure your fingertips maintain contact with the silver strip during your entire treatment. This allows the ionic technology to extract dirt, oil and debris, plus boost penetration of skin-care actives during your treatment.- Step 1: Wet skin with DERMAPORE+ Prep Mist before using Extract Mode. Re-mist as needed (skin MUST remain wet for entire treatment)- Step 2: Glide the tip of the spatula over any clog-prone areas including nose, forehead and chin. Keep your fingertips on the silver strip to allow the ionic technology to function- Step 3: Apply your favorite serum, moisturizer or treatment mask and glide the flat part of the spatula over skin (keep your fingertips on the silver strip)- Step 4: Hold skin taut with the opposite hand. Glide over skin using gentle-but-firm pressure. Visible debris from pores will build up on the spatula. Wipe clean as needed- Step 5: when finished, use warm soapy water or alcohol to wipe the spatula clean. Apply your favorite serum, moisturizer or treatment mask (sold seperately), then switch to INFUSE mode to help boost penetration of skin care actives.
DERMAFLASH Dermapore+ Ultrasonic Pore Extractor In Stone
Compare Across 800+ Stores
DERMAFLASH DERMAPORE+ ULTRASONIC PORE EXTRACTOR & SERUM INFUSER - GREY
DERMAPORE PLUS N/A. Features: Ultasonic vibrations at 35k HZ/min unclog pores with minimal pressure and zero irritation. Ionic technology draws out impurities from deep within pores and improves absorption. 2 Modes: Extract & Infuse. Custom curved stainless steel spatula. Use with Dermapore+ PREP MIST to optimize your results. Used and recommended by estheticians. Research Results: 100% said skin felt significantly cleaner + smoother*. 97% said skin looked clearer*. 97% said it was easy to extract dirt + oil from hard-to-reach areas*. 97% had less oily skin**^. **Instrumental analysis immediately after use with PREP MIST. **^Instrumental analysis immediately after use with PREP MIST (measured area: forehead). Includes: DERMAPORE+ Device. USB Charging Cable. DERMAPORE+ Prep Mist (0.5 oz). Quick Start Guide.
DERMAFLASH DERMAPORE+ ULTRASONIC PORE EXTRACTOR + SKINCARE INFUSER
What it is: With 35K Hz vibrations per minute, the DERMAPORE+ is every estheticians best friend for finger-free extractions with no redness or irritation.What it does: The custom-curved spatula has positively charged ions, which work synergistically with the negatively charged ions in Prep Mist. Together, they act like a magnet to gently extract pore-clogging dirt, oil and blackheads from wet skin. A separate Infuse mode helps deliver skin-care actives deeper into your skin, while boosting circulation with an invigorating micro-massage sensation.Set includes:- DERMAPORE+ Ultrasonic Pore Extractor + Skin Care Infuser- DERMAPORE+ Prep Mist Spray (0.5 oz.)- USB charging cordHow to use: Use once per week until skin becomes accustomed, then use as often as desired. Always use with PREP MIST for maximum pore-clearing benefits. Skin must remain wet during the entire treatment. Make sure your fingertips maintain contact with the silver strip during your entire treatment. This allows the ionic technology to extract dirt, oil and debris, plus boost penetration of skin-care actives during your treatment.- Step 1: Wet skin with DERMAPORE+ Prep Mist before using Extract Mode. Re-mist as needed (skin MUST remain wet for entire treatment)- Step 2: Glide the tip of the spatula over any clog-prone areas including nose, forehead and chin. Keep your fingertips on the silver strip to allow the ionic technology to function- Step 3: Apply your favorite serum, moisturizer or treatment mask and glide the flat part of the spatula over skin (keep your fingertips on the silver strip)- Step 4: Hold skin taut with the opposite hand. Glide over skin using gentle-but-firm pressure. Visible debris from pores will build up on the spatula. Wipe clean as needed- Step 5: when finished, use warm soapy water or alcohol to wipe the spatula clean. Apply your favorite serum, moisturizer or treatment mask (sold seperately), then switch to INFUSE mode to help boost penetration of skin care actives.
